Search found 23 matches
- Sat Dec 04, 2021 12:28 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Leak? 24RB ever seen this area water damaged
- Replies: 4
- Views: 2441
Re: Leak? 24RB ever seen this area water damaged
Hi Bill, The reason I suggested a leaky toilet valve as the possible source of water damage in that area is because when my valve leaked some of the water found its way under the wall between the bathroom and the rear door and cause the vinyl flooring to start buckling at the top of the steps from t...
- Thu Dec 02, 2021 7:09 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Leak? 24RB ever seen this area water damaged
- Replies: 4
- Views: 2441
Re: Leak? 24RB ever seen this area water damaged
You might check the valve at the rear of the toilet. I had a leak there that went away after replacing the valve.
- Thu Oct 14, 2021 7:06 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Clay with a Catalyst ?
- Replies: 2
- Views: 2958
Re: Clay with a Catalyst ?
It sounds like a stick of J-B Weld epoxy, which comes in various types for repairing different materials (metal, plastic, wood, etc.). You can buy it at ACE Hardware and probably at almost any other hardware store.
- Thu Oct 14, 2021 6:27 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: ISO good mechanic near Portland, Oregon
- Replies: 2
- Views: 2161
Re: ISO good mechanic near Portland, Oregon
I've had good luck with Northside Ford, 6221 NE Columbia Blvd in Portland. Ray in the service department at 503-493-5548 has been very helpful. if you decide to try there, mention my name to Ray.
- Fri Jul 02, 2021 4:41 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Actual Fuel Capacity?
- Replies: 5
- Views: 3371
Re: Actual Fuel Capacity?
I was HOPING that the gauge reading empty would mean that the E450, like most other vehicles, still had a little bit in the tank. It looks like that is the case, and that when the gauge hits the E there is still about 5 gallons left and that those remaining gallons are actually usable. Thanks for re...
- Thu Jul 01, 2021 6:27 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Actual Fuel Capacity?
- Replies: 5
- Views: 3371
Actual Fuel Capacity?
Due to a combination of events too embarrassing to relate, I recently almost ran out of gas in my 2002 24RB. The gauge buried itself in the "E" a ways before I made it to a gas station. It took 50.2 gallons to fill up. The manual says the gas tank holds 55 gal. Does anyone know if that 55 ...
- Tue May 05, 2020 1:59 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Bathroom door hinge replacement?
- Replies: 0
- Views: 2166
Bathroom door hinge replacement?
Does anyone know where I can get a replacement for one of the bathroom door hinges on my 2002 24RB? The hinge itself is fine but one of the screws attaching it got loose and the backing plate that fits into a slot in the door must have then fallen out and was lost. Thanks!
- Tue Sep 11, 2018 3:27 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Replacement of cabover (skylight) window on 2002 24' RB
- Replies: 0
- Views: 2337
Replacement of cabover (skylight) window on 2002 24' RB
The cabover skylight window in our 2002 24' RB fogged up a couple of years ago, then began leaking this year despite much caulking and recaulking around it. I recently had it replaced by RV Glass Solutions in Coburg, OR and they did a TERRIFIC job. Total cost was $430. Great people to work with. No ...
- Fri Jul 22, 2016 1:45 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Curtain air duct
- Replies: 2
- Views: 3542
Re: Curtain air duct
Another approach that has worked well for us is to mount a small Coleman tent fan on the end wall of the upper cupboards, facing forward toward the cabover bed, at the foot of the bed. This circulates a nice gentle breeze through the bed area and is especially helpful to anyone sleeping toward the f...
- Fri Jul 22, 2016 1:28 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Drag Rollers - replacement wheels
- Replies: 6
- Views: 9907
Re: Drag Rollers - replacement wheels
Sorry to take so long to reply. The part number from my local distributor, Industrial Caster and Wheel, is 524-PR-12 for an exact replacement for the one used by Bornfree, with a delrin (plastic) central bearing. The wheel they had in stock and that I got was slightly different in that it has a roll...
- Mon Jul 18, 2016 6:35 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Drag Rollers - replacement wheels
- Replies: 6
- Views: 9907
Drag Rollers - replacement wheels
One of the drag roller wheels on my 2002 24RB was completely worn out so I called Kim at Bornfree for a replacement. He was very helpful as always but was unable to send just the wheel, had to sell me a complete new caster and wheel assembly for $50 plus $25 for shipping. The new caster had the name...
- Mon Jan 06, 2014 2:04 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Baseball spring training
- Replies: 3
- Views: 3972
- Sat Dec 28, 2013 6:53 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Baseball spring training
- Replies: 3
- Views: 3972
Baseball spring training
My wife and I are planning to go to the Phoenix area in March to see some spring training games. Does anyone have any suggestions or tips?
- Mon May 25, 2009 11:16 am
- Forum: General and Technical Information, Questions, and Responses
- Topic: TV system upgrade
- Replies: 7
- Views: 8163
TV system upgrade
I replaced the original 13" analog TV in our 2002 24RB with a 19" LCD HDTV with a built-in DVD player, and mounted it to the wall (backing up to the side of the refridge) using a bracket that tilts, swivels and goes in and out. To keep it secure while traveling I attached cup hooks to the ...
- Tue Jun 03, 2008 3:22 pm
- Forum: General and Technical Information, Questions, and Responses
- Topic: Generator cranks but won't stay running
- Replies: 4
- Views: 4984
Generator cranks but won't stay running
I had a similar problem when I forgot to flip the "winter/summer" lever on the generator back to "summer" this spring.