Born Free Leap'n Lions RV Club Info & Discussion Forum

Wow - So basically each white wire should close a black wire circuit but the whites are instead tied together. So the circuits have been wired in parallel when they would be better off as isolated circuits (like you mentioned that you created on your other RV).... That is good to know I will have my...

Thanks Norm - Great suggestions re the no-ox and doing a re-wire to isolate each black wire with its own circuit breaker. I am going to suggest this to my RV mechanic next week. I need to go pull out a circuit diagram to understand the purpose of those white return wires!! Thanks once again! Angela

The screws on the electrical panel all looked pretty good and tight. The tripper also looked physically good One wire has burnt insulation (see attached) - I am not sure if it is the cause of the fuse tripping .... but it does tell me that I'll need to get the electrical wires checked and the one in...

Thank you so much for such a clear explanation !!!
I will do this !!
- Angela

elect.JPG Hi there All of a sudden, the MAIN circuit breaker on the electrical panel of my 2003 24RB has started to intermittently trip when connected to 50A shore power via a 50 to 30A adapter and external surge protector It trips under high load and will immediately reset if I switch the main cir...

In looking at the report from Cummins, what had happened is that the starter gear (a pin) had locked into the flywheel. You can feel the flywheel by putting your hand, top left of the generator unit, about a foot back - You feel a wheel with notches (turbine-like) ... Shake it around a bit and the s...

The generator was checked out by Cummins in Hayward, CA. It turned out that there is a pin that got stuck in the fan wheel, top left and about a foot back (reachable with your hand). To fix, Just put your hand back there till you feel the rotors of the wheel, shake the wheel back and forth and the p...

Thank you both - Yes - It has been regularly serviced and I use it quite a lot. It looked a bit low on oil so that may have lead to its demise. I would love to rebuild it, if that makes sense !

Does anyone have recommendations for places where I could get my Onan gas generator rebuilt or a trustworthy source of rebuilt/used generators? I am located just South of San Francisco, CA. The generator cylinders are stuck so my mechanic recommends a rebuild or replacement. I am using original gas ...

Indeed !!

I installed 4 Michelin LTX's on the rear of the coach. A noticeably smoother ride! Thanks for the recommendation!

Hi there Has anyone have up to date recommendations on 12V Digital TV replacements for Ye Olde Cathode Ray tube TV that I have side mounted by the fridge in my 24RB ? My rig does not have an inverter What size screen would you recommend? What models.... I spotted some Jensens on Amazon and PPLMotorh...

Thanks Bill - Typo on my part - I meant that the LTX's had a better ride, as you had mentioned...

Thanks a million -- I'll get the LTX's ordered and installed next week!

Thanks -- The big debate - LTX vs. XPS Rib. Is the LTX these days more prone to sidewall cracks than the XPS I noticed on one of the older BornFree forums circa 2006 that the LTX's had some sidewall cracking issues but understand that the ride will be better on the XPS Ribs... I put at least 1000 mi...

Thanks ! Do you recall which Michelin tire you used?