Page 1 of 1

Sync electric door lock with remote?

Posted: Mon Jul 01, 2019 9:59 am
by Vlamgat
Has anyone done this? I had to replace my HDC-008 key pad and despite many attepts following the instructions, the original remote will not sync to the new pad. Is there a trick to it? One of the challenges says that the process must be accomplished within 5 seconds of turning the power "ON". But on our BFs, the power is always ON. So i tried disconnecting the pad, reconnecting and then exercising the process within 5 seconds but that too did not result in the remote learning the code.

Re: Sync electric door lock with remote?

Posted: Tue Aug 06, 2019 1:54 pm
by Vlamgat
Just to close this out: You have to trigger the Start sequence of the Key Pad by removing it from the door; remove the power wire;then: Reconnect the power wire then press 1/2 AND 9/0 AND any button on the remote ALL within 5 seconds. The door lock will lock or unlock to signify a successful coding. Important that the pus button sequences are all accomplished within the SAME 5 seconds, something that is not clear from the instructions.

Re: Sync electric door lock with remote?

Posted: Fri Sep 13, 2019 6:07 pm
by John S.
Thanks

Re: Sync electric door lock with remote?

Posted: Sat Sep 14, 2019 9:44 am
by bcope01
Geez, who designed that? Thanks for the info.

Bill