Levelers for a 26' RSB unit

harrisgowing · Post by **harrisgowing** » Wed Feb 13, 2008 10:08 pm

Duplicate post was deleted by the bfadmin. The typical cause of most duplicate posts is that the submitter clicked on the Submit more than once!

bcope01 · Post by **bcope01** » Thu Feb 14, 2008 10:21 am

Judy, I tend to agree with your husband, Chuck.

Close is good enough!

Bill

Mike Astley · Post by **Mike Astley** » Thu Feb 14, 2008 6:50 pm

I did the math for our 26'. Don't remember the exact answer but the simple answer was if you use those little stick on levelers that are graduated in inches up to 7" off level, they would have to be pegged before you were even getting close to being too off level for the refrigerator specs of the 3 and 6 degrees.

So we stuck one on each side of a corner of the kitchen cabinet under the counter-top. We can glance at them both with one glance, on the way out the door to confirm we're OK.

7" is a sizable tilt and you will soon be "calebrated" and only have to look at the levels occasionally.